Posts

Chosen Solution I have noticed that the display frame of my note 10.1 2014 ed is detached (I can see it o the home button .Is not very mutch maybe a millimeter (I can put my fingernail inside) but if I push it down that remains down and everything it seems “normal”.I must say that touch,home button and all the other functions works well so I have not any problems.After a wile the “problem of the display frame came again back,i push it down and so on… This is my question (why I’m not a repairing technique of Tablets....

Chosen Solution Replaced the usb ribbon cable on my Tab 3 p5210 and now my home button doesn’t work it’s connected up just fine played with the ribbon connection. Don’t have the old cable to compare revision numbers but replaced it with a 1.0 It shouldn’t be an issue, yours is probably just faulty. Yes it does matter. The REV. No. always have to match. i myself dont know what REV stands for, but from experience i know that the REV almost always matters

Chosen Solution I am waiting for this charger the next week and i would like to ask, can i leave it permanently connected even when i am not charging anything? Does this affect the charger? Secondly does it have overcharge and short circuit protection? that is a simple 12v to 5v regulator. It will supply its rated current to anything connected, the same as charging from you computer port. It is up to the device to control its charge....

Chosen Solution The Dryer does not have power going to it. Checked outlet, it has power so its not a power outlet issue. The inside light and control panel won;t light up. no beeps nothing. I open the bottom panel and check to see if there were any loose wires, none found. Cleaned out the fan and vent and vacuumed out all lint. Check back electrical cord and it seems to look fine....

Chosen Solution So my screen has been broken so I replaced it with a eBay replacement that came with everything, screen, speaker, prox sensor, home button. Everything works fine, except for the touch id (expected since I swapped home buttons). I swapped out the speaker to another one and still the problem remains. I also tried to restore the phone, no luck, and also inserted reinserted a headphone into the jack to see if it was stuck in headphone mode....

Chosen Solution My car has an oil leak. It also blows back oil through the dip stick Sounds like your PCV valve needs replacing. mike vernon possibly blown piston rings. Check or replace your PCV valve as suggested and then do a leak down test. It will tell you a bit more about what is going on with your Camry

Chosen Solution My Screen was damaged and I’ve got a replacement but the ribbon cable off the original earpiece assembly was also damaged and I’ve had to also replace the assembly. As the sensors are paired with the phone once replaced the Face ID is not working. Can the new assembly sensors be programmed to work with the phone to re-enable the Face ID feature? Unfortunately, the Face ID assembly cannot be repaired under any circumstances except by Apple or their authorized service providers....

Chosen Solution I’ve replaced the WiFi antenna on my I phone 6 and now my finger I’d sensor doesn’t work, whenever I try it just says unable to set up finger id Hi Gary! I recommend you open up the device once more to check to see if there is poor connection with the fingerprint sensor. Try disconnecting and reconnecting it. Then restart the device before using it. You should also check for home button flex....

Chosen Solution Dear, I repaired my ipad mini 4 for the first time, I have an problem with the fingerprint function. When i replaced the home button and try to test the screen and the function ,my fingerprint does not respond anymore. I checked in the touch id options and it is not turned of so i think its not broken, also i can just switch it on and off. When i had this problem with an iphone the ios gave an error that the touch id will not work....

Chosen Solution How do I get past the boot up password I found this: https://h30434.www3.hp.com/t5/Notebook-B… it looks like you can try one of these two passwords: 47498324 or 00586459 according to an HP employee: Use the unlock code posted above to enter the BIOS Disable all passwords that are enabled If asked for current password - type the unlock code For new password, just press ENTER key Repeat the same for verify password column....

Chosen Solution GE GTWN4250D0WS top load washer, purchased 10/2013 A few months back it started making loud banging noises while accelerating for spin cycle, and ONLY spin cycle. I changed the black stabilizers at the four corners, the suspension rods are in good condition, this past week I changed the main tub bearing, and today tightened up the counterweight which was surprisingly intact. The drive belt was exceptionally taut, the pulley is aligned, there aren’t any obstacles to the tubs movement within the housing… I’m dumbfounded....

Chosen Solution Hello everyone As the title suggests… I recieved an iPhone XS with a damaged LCD. I managed to find another iPhone XS with a working LCD and pulled the display from it, fitted it with no issues to find that the bottom half of the LCD doesnt work. Initial thoughts, %#*@ I damaged the FPC maybe blew a diode or shorted something - Nope. Tried an aftermarket LCD and it works fine....

Chosen Solution I have an old MacBook Pro mid 2012 which had a broken screen. I sourced a replacement screen from a dead laptop and fitted it, but it has SUCH an odd issue. I can install any version of OS X / MacOS from Mavericks to El Capitan and it works absolutely fine. All hardware tests OK both in the Apple Hardware Test and using Tech Tools Pro If I upgrade or fresh install MacOS Sierra, High Sierra, Mojave or Catalina, the installer runs absolutely fine, until the final reboot when it runs the welcome routine....

Chosen Solution I did a Google search couldnt find much but just to replace the keys. I have a customer that spilled liquid on the laptop. Trying to figure out cost , I don’t have the laptop in my hands. It’s probably more than KB looking at the stock pics of it. You would need to replace the entire keyboard unit. The part for such repair can be found easily on eBay....

Chosen Solution The middle of my Fitbit (below the screen) had started to separate with the watch. If I push it back in it will soon pop out again. The watch itself is still fully functional but I’m worried that the watch will get more damaged if I carry on running with it. @adam2208 ,Adam, If watch still under warranty, have repaired under warranty by manufacturer. Even if not under warranty use the link below to contact Fitbit and see what they can do for you, ask for a resolution manager if need be....

Chosen Solution Hey there. After a full system cleaning, my PS4 wont boot up after touching the power sensor. (First gen model) But when I try to insert a disc, it turns on, beeps a 2nd time and goes into Safe Mode. (Ita like the button is held down) If I choose one of the options, reboots, beeps a 2nd time again, Safe Mode, then beeps a 3rd time and shuts itself down....

Chosen Solution In short, title a few months ago the charger on my Asus x555L started acting strangely, only charging when it was turned at a certain angle. now it refuses to charge entirely, and the charger will not stay secure in the port as the port is broken. how would I replace the port with a new one, thereby fixing the issue? The charger port is soldered onto the board meaning you’d need either a hot air rework station + soldering station to remove the port or a soldering iron station + solder sucker to remove the old solder to remove the old charger port....

Chosen Solution I tried to charge my chromebook but later on it stopped charging and it is not powering again Hi, Have you checked that the charger’s output voltage is 12V DC at the output plug of the charger? It may be if the charger is not working that the battery has finally discharged and the laptop won’t start as the battery is flat and the charger is also not working....

Chosen Solution I’ve been repairing some back light issues in 50-60+ inch TVs. The hardest thing was removing and reinstalling the actual screen. I broke a couple while removing and installing. I decided to get suction cups from Home Depot to help with this process. It just seems easy now but I left the suction cups on and the last one left a 4 inch circle on the screen. The picture works in the circle but it is a clear defect....

Chosen Solution I need more storage on my MQD32 MacBook Air. Moreover I don’t want to buy the most expensive SSD. I found some models on the internet from a various brands and models but one of most important things that I want to know is how to figure out which Type of SSDs are compatible with my MacBook Air 2017 ? In the other words what is their connectors and speeds....