Posts

Chosen Solution washes with cold water only.it does not heat water Open it. Look for the heater and measure its resistance. For a 230V Type ist should be near 24 Ohm, for a 120V Type around 10 Ohm. And: there is a pressure switch that ensures that the heater only works when there is enough pressure. Hi - I was able to repair the Bosch dishwasher with this exact problem. It is an issue of the relay as described in this video: https://www....

Chosen Solution So a few days ago my charger cord ended up going dead, (meaning i have to move it to a certain position in order for it to work.) i didn’t really mind until last night when my tablet battery was at one percent so i turned it off. Next day the cord doesn’t work at all, and using other cords around my house don’t work either. (I use USB cords the most....

Chosen Solution screen is black but can still hear notifications Try a hard reset ( Hold home + Power until apple logo pops up) if that doesn’t work then you probably need to replace the screen. Check the connections. I have seen a lot where the LCD connection comes loose but the others are intact From what you describe I think I have a similar problem. You need to display the screen/ the display....

Chosen Solution I tried to change motors. After realizing I couldn’t get the pulleys off, I reassembled everything and Motor runs, mower spins but pulley won’t engage the drive. Clutch and Transmission are operational. Pulley makes a metal rattle sound like ball in spray paint can. How do I repair this? @therev check the clutch on your PTO pulley. Testing If the electric PTO clutch is not engaging or is suspected as a cause of electrical problems, use the troubleshooting steps....

Chosen Solution my ipod is disabled how can i enable If it’s password disabled, simply attach charging cable from your phone into any computer with iTunes and restore. If it’s iCloud Activation Locked, then put Apple ID and Password in.

Chosen Solution Does anyone know how the FaceTime HD Connector is integrated with iBridge ? I assume there is a connector somewhere but I can’t seem to find it. OK now I get your question! iBridge is just a functional name for the T1 chip to the system USB connection (hardwired). Like the internal USB hub the system also has. It’s not something physical in the sense you can connect it or disconnect a connector without having issues....

Chosen Solution I have this condition where my iphone 5s 32gb stuck on the logo, it wont turn the ios properly. I got to the service and he said my phone needs to change the harddisk, which is really pricey, i never over loaded my phone, i just using it for whatsapp, line, instagram, and mobile legends game. The he day before it worked just fine until i charge my phone and i found out my cable are broken, and it wont charging and it died for a ll bit too long, then i go tothe ibox and they jumper my battery it turned on but wont load anything except the apple logo, what happend to my phone to be exact?...

Chosen Solution where is the thermostat located in a 1993 ford ranger 3.0l v6 Hey to find the t-stat just follow the upper radiator hose from.the radiator to the engine and then your thermostat will be right around this area. But you can always google this and pull up.images

Chosen Solution i have Ford fiesta hatchback ang the fan doesnt work with our the aircon.f i dont turn on the aircon the coolant becomes very hot and it overflows.please need some help. thank you. It has temp sensor/fan switch that will send a signal to the relay and then send power to the fan. It’s either the fan switch or the relay.

Chosen Solution 2010 Ford Fusion radio LCD screen blank Try to reset it by pushing power and right arrow at the same time, hold for 15 seconds. If that don’t work I will research where your radio fuse is located so you can check that.

Chosen Solution laptop in “safe mode” How do I make it normal operating mode? well the first thing to try to do is to restart your computer. It normally only goes into safe mode when you request it. try powering down completely even take the power source away for a few seconds (ie battery or ac plug ) and then turn it on again. I hope that this helps and that you are out of safemode soon

Chosen Solution Hello everyone, how to replace the charger port on the Ipod touch 4? You will of course have to totally disassemble the iPod. The dock connector is solder onto the board. You will have to do lots of soldering. You will have to un-solder two anchors and about 30 connections, they are very small and close to each other. So you have to take extra care not to shorten the pins out....

Chosen Solution I wana replace my Samsung Galaxy Note 3 charging port. I found something mabye simlar to my virsion. my phone virsion is N9005 but this is N9005P. are there same? [linked product missing or disabled: IF232-024-1] ist Compatible with mine or this is Amarican virsion and will not work corrctly with mine? I would look for one that says N900V (V is roman numeral for 5), although the other one may work to charge but may have issues with signal....

Chosen Solution how to clear the circle with line in the middle, when powering up my MacBook Pro 15 inch That is an indication the system can’t locate the OS files to boot from. Try restarting the system and quickly press the Option key to enter into the startup manager. You should get a listing of the drives/volumes which offer Athena system files, select one and see if that worked. If you don’t see any listed the the drive is either damaged or missing or the drive cable is bad....

Chosen Solution My macbook’s inverter died, I think, the screen isn’t lighting, I’ve looked everywhere, and I’ve tried everything. I got the computer fully apart, but then a WTF moment happened- The clutch cover screws (2 of them) came pre-stripped from Apple. What the &^#? I can’t get to the inverter now. What can I do? Is there another way I can get the &!^ clutch off? Thanks Dave You’ll be pleased to know this website offers several tools at your disposal, such as precision screw extractors, a manual hand drill as well as drill bits for the smallest of screws!...

Chosen Solution So my battery was dead last grass season, I kept jumping it off to cut the grass. This season I go to do the same and it fires right off with the jump start but when I take the leads off the mower shuts down. Is this due to the battery being bad or is it a cause of another problem? @jsimmons92 this"when I take the leads off the mower shuts down" happens when your alternator does not work....

Chosen Solution Hi I’ve got a mode dial that’s damaged, i.e. the button is damaged but works. I need to replace it along with the top plate. Can I do this without dismantling the camera? Thanks Yes I do just seen video Thanks

Chosen Solution cant operate my lap top showing error hard drive 0. error code 2000 -0146 Hi Smith ! This error message indicate your hard drive is dead. You can change by an SSD (you win in performances).

Chosen Solution it says in red color to try back over i million times and that password is invalide which i know it is not also prior to this disfunction the slide on the tough panal refused to work…please help! If there is something wrong with your iPod 3rd generation backup password, I think you can try to visit this article from a SmartKey Password Recovery website: http://www.recoverlostpassword.com/artic… Hope it helpful....

Chosen Solution The brightness on the display cannot be adjusted. The slider bar does not function. Problem solved! I didn’t know it at the time but there is a diagnostic tool that loaded when I started the tablet. Running this tool corrrected the issue of the display brightness.