Chosen Solution Galaxy j3 OS Android Get 2 messages - 1.No service 2. Not registered on network Status -SIM inside, Screen works fine, Battery full @shimba contact your network provider. This does not sound like a hardware issue on your phone. Your Sim maybe inside but that does not mean it works.
Chosen Solution The car cut off on me and left me stranded twice I replaced the distributor it ran good for 2 weeks and then it did it again it would turn over but not all the way so we hit the starter with a hammer and it cranked but they say the starter is not bad do I need to change the ignition coil or the alternator @nikopink the starter would not be the reason why your car would “cut off”....
Chosen Solution Moto G5 plus, phone end of the charge cord overheated, melted cord end and plastic around the charge port. (Using the Motorola turbo charger) The connector has never seemed to seat properly in the charge port on the phone. It loses connection of the the cord or phone is jostled even slightly. Thinking there may be debris in the port I have attempted clean it out gently and with compressed air....
Chosen Solution Hello, So I have this problem, when I plug in my psp, the charging light won’t turn on, and it sometimes turns orange for a moment then turns off again. the psp is fully functional and I can turn it on, but it has no batteries detected. I want to know if it’s the psp’s problem or the battery?? try cleaning the usb port https://www.youtube.com/watch?v=GIoTlY1W… Be sure to use the ac charger and not the USB....
Chosen Solution The female connection my tv has broke off inside. Line is for cable or antenna to receive signal @judyswish4 post some images of what the damage looks like. Use this guide Adding images to an existing question for that so that we can see what you see. It is possible that this can be repaired by re-soldering a new connector or possibly replacing a board. Cost and skills/tools will be a factor....
Chosen Solution This mac had a spill a long time ago. Was working fine for a while and then died. After Logic board was replaced, the Control key doesn’t work anymore. My question: With only one key not working, should I suspect the keyboard ribbon, or does ribbon related problems always affect more than one key? If it’s the keyboard, is there a chance to fix it, or would I need a new keyboard?...
Chosen Solution Cosmo not lifting the cubes up..what’s wrong with him the lifthook is missing If your cozy won’t lift up cubes you will want to get a new lift motor or buy a brand new cozmo Cozmo arms are not working
Chosen Solution As the title suggests I have damaged my screen and would like to replace it. I can take most of the device apart however I am having issues removing the bezel. under the little rubber feet on the bezel may be screws also check for flat round dots too not all the screws have rubber on them undo all the screws, the bezel will be clipped and probably taped down, pull bezel towards you slowly, make sure not to damage the wifi antenna here is a video showing https://www....
Chosen Solution The Plantronics Voyager5200 looks almost identical but is in fact different (Rtings has side-by-side pictures). Do the battery replacement instructions for the Legend also work for the 5200? Thanks! basically yes they are almost identical. Just be sure you get the right battery with the right leads.
Chosen Solution Hi, I am trying to drill a pilot hole but the second the drill bit touches the wall(wood) it stops spinning. The drill keeps spinning but the bit doesn’t. It spins fine when not against the wood. It sounds like the chuck is not tightened….does the drill bit stop and the chuck keeps spinning, or does the entire drill stop spinning? Make sure the chuck is tight and ease up on the pressure your putting on the drill....
Chosen Solution I dropped my UE mega boom speaker and now its dented. I can live with it but it sounds like the speaker is hitting the dented part with heavy base. Is there an easy fix? Most likely the drop was quite powerful and did some damage to the speaker too. Take the speaker out, if possible and see whether the coil is still centered around the magnet. Also check the cone for damages....
Chosen Solution So I have a Kenmore 90 series dryer. I recently replaced all of the rollers because they were shot and one roller had completely fallen off. While I was in there I vacuumed all of the dust out of everything. After that repair my dryer will now sometimes stop mid cycle. After stopping, it will not restart for a while until it cools down. This also happens if I open the door mid cycle - it then will not restart until it cools down....
Chosen Solution The door open indicator light was on even when the door was closed. I did get it to turn off. However, none of my interior lights will turn off since that happen on 3/13/18 unless I turn it off from the dimmer switch on the turn signal wand… And that’s ok in the day not to be able to see dash lights but not so good for early morning or when it’s dark!...
Chosen Solution The phone itself is not responsive, black screen stuck in DFU and can get out of it, when restoring the screen lights up and apple logo appears and that’s it nothing more, after few minutes iTunes gives error 4005. serial number shows n/a. I have tried every solution I could found, using multiple PCs and Macs, different USB, restoring without front assembly. nothing worked. Any answers?
Chosen Solution My mate gave me a phone few weeks ago and for some reason the phone was blocked. He was confused as it was an upgrade from his current phone and he ain’t used the phone for about 10 months. He called up EE and they unblocked it. So I put my o2 sim card in after 48 hours and the phone worked fine. 3 days later the phone was blocked again....
Chosen Solution I switched on the tv yesterday and the colours are wild! Skin tone is very orange and all other colours are way off. I’ve tried adjusting but it’s not helping. TV has worked perfectly up until now. Any ideas? Many thanks ☺️ @heather7 you need to give us the complete model number. This sounds like you are looking at a solarized image. This is most commonly caused by a failed gamma IC on the T-Con board....
Chosen Solution I have had an external USB Western Digital Hard Drive of unknown make for a while now and one day I woke up to find that it was no longer being recognized. I felt it and it still felt like it was spinning but there was an obvious clunk in it at a regular interval, as if it was a motor pushing something forward and getting pushed back. Through my research I found it might be related to the arm holding the heads and I would like a second opinion....
Chosen Solution The Optic CD drive is not ejecting the Disk; I finally got it out with the use of a flat metal object. The clock is working so It may not be a faulty PRAM battery, although I do have a spare one for this A 1247 Mac Mini, it is a BR2032, 3 V Button Battery. The disk icon was not showing in the side bar, so I could not use the instillation disk and other disks could not be identified, ‘‘safari does not know which programme this disk was created on’’ was on the sheet page for these....
Chosen Solution I was gifted a Mac Mini model A1347, I believe its a late 2014 model. 2.6GHz Intel Core i5 with 8gb of LPDDR3. I was told the Mac has only been used a handful of times since its been purchased. When I tried to boot, I got a flashing ? folder, and after research I’ve found that this is most likely because the mac no longer has a working operating system....
Chosen Solution Boots and gives a prompt to go to www.apple.com/support/ipod upon startup, it continues to give the same message after resetting from the diagnostics screen and by pressing the center and menu buttons. also is not recognized by my pc although I think that is just because It needs to charge from the wall for a while first because the battery is so low, sounds like a dead internal drive, check youtube....
