Chosen Solution I have replaced the ear piece and it is still very quite on max volume. Have to take calls on loud speaker? Hi, Is the audio level OK when using a headset? Has the phone been dropped or gotten wet at all? Some things to try to resolve the problem or to isolate where it may be. If you haven’t already done so (you never mentioned it): Wipe the cache partition and check the audio level in the earpiece receiver....
Chosen Solution Hello Everybody, I had a big problem here. My iPhone 3G 16gb cannot restore as it appeared a warning sign ‘The iPhone could not be restored. An unknown error occurred (6)’. Can you guys help me? What happend to iPhone? There is 1 repair guy told me that my Logic Board is spoiled and need to replace. Any advise? Thank you, Hairi - Malaysia. This is usually caused by another program changing the default packet size for iTunes in a Windows environment....
Chosen Solution image was from Apple Diagnostics and TG Pro. I tried resetting SMC to no avail. I need some help. My fan is constantly on. I have downloaded TF Pro and it does say that the GPU sensor may not be working properly. The GPU sensor registers at 32 degrees celsius in TG Pro. Even the override and auto boost in TG Pro doesn’t keep the fan from running at full tilt 6500 rpm....
Chosen Solution My iPhone 5s fell in water and will not turn on if I get a new motherboard will my phone work again? @just_ that is a depends. If it is only the logicboard that is shorted out then yes. If there are any of the peripheral device that are shortening out the logic board, then no. You did not tell us anything about what you have tried to repair your phone and to test it....
Chosen Solution SB-600 doesn’t change focal lenght with zoom, always show at 14mm With the SB600 and above, there is a wide flash adaptor that spreads the beam to its maximum angle of 14degrees. It rests horizontally on the top of the light. You may have pulled it out inadvertently. Use your fingertips to see if the wide flash adaptor is down in front of the bulb. If so, it flips up from the bottom....
Chosen Solution My samsang s1 when i put it on charge the battery light come on and then it show me a red ? On top of my screen what can it be Charles Robert that could be a bad battery as well as a bad charger or a bad cable. I would start with a replacement of the battery.
Chosen Solution Please help me I am in problem , how can i know my password try power + volume up + menu to reset the pattern I have forgotten pin of my tizen device .. please help me .. I have forgot mobile pin plz help Pattern look to unlook
Chosen Solution My nobis 7" tablet want let me factory reset it and I dont have a volume button how can I get inot my tablet? Hello Kim, Just follow this simple steps to factory reset your Nobis 7 tab, Turn off your Tablet *Press and hold Power key and Volume down key simultaneously Release the keys when the recovery mode appears, Navigate using volume up keys Select “Wipe All user data” and use the Use Power key to enter the selection...
Chosen Solution Is it possible to only replace the front glass on this model? i don’t want to replace the screen as it is working 100%, just the glass is broken. If yes, what part number do i need? Thanks for your help @dbeerd this would be the part you need. Something like this video should get you there.
Chosen Solution The battery dead and bulged and it pushed a front glass to separate from the display board in one end, please how can I repair it? change the battery and the display assembly should fit back to it original nature or apply This Kind of Glue (or any similar glue) the hold the sceen back to its body frame if needed.
Chosen Solution Im hoping someone can help who has experience in this field. Im looking at setting up a personal home workshop repairing glass only. I know what equipment I need to conduct the repair but I wanted to know if a vacuum laminator is necessary? would I be able to place the glass on the LCD and put it straight in the autoclave? Or do you need to have a vacuum laminator as well?...
Chosen Solution Can the ambiant temperature sensor be replaced? About how much would that be and where do I take it please? You would need to find the sensor itself and see if there’s any sort of identification number or SKU on the sensor. If there is, get a replacement and install it, making sure to replace any thermal interface material or tapes. If there isn’t, then try posting a picture of the sensor to see if there’s any gear junkies out here who can identify it....
Chosen Solution I have a push lawnmower that has transmission control, and blade engage control. I have checked spark and it’s very strong, compression is low but seems present, fuel flow from the tank, to the cut off, to the carb is ok, carb fills with fuel, but there’s no flow into the chamber. I got it running by adding a cup of 10-30w oil and started due to starting fluid then died, to keep it running I push 1 second bursts into the intake hoping it will start sucking in fuel, it still shows no fuel flow....
Chosen Solution Why does my tablet take 20 hours to charge up Many tablets come with their own specific chargers and they have various voltage and amperage capabilities so that the tablet can charge at the set rate of that unit. Many people loose their charger and try charging their tablets using a charger with the same type of cable since many android tablets have the same type of connector for their charger as their android phones....
Chosen Solution My laptop suddenly stopped turning on after taking a small fall. I have tried the SMC restart, variations on holding the power button down, etc, and no luck. I have taken out the battery and tried to turn the computer on while plugged into the charger. In all cases, the magsafe light stays green (never turns amber, even when plugging/unplugging and pressing the power button) but the computer never turns on....
Chosen Solution I’m trying to copy photos from my mac (from Photos app) by exporting them to a USB, and I keep getting this error: “Could not write file to destination(1,016)”. What can I do? try quitting out of photos and reopening, and restarting. I have noticed Photos is a very, very finicky program. Try dragging them to your desktop then to the USB. YUP- Once Apple abandoned Aperture for the truly mediocre “Photos” program, I have been struggling to manage all of my photos....
Chosen Solution I accidentally put batterie in backwards then it wouldn’t start so I replaced solenoid and it still won’t start. It turns over fine but won’t start. It’s got different batterie now also so that’s not what I messed up. It’s just not firing for some reason. The solenoid I bought has mbis on it and my original one once had two on it. But I’m possitive I hooked it up correctly it’s a F250 4x4 with 5....
Chosen Solution I changed the battery of my Apple Watch, but I accidentally have damaged the cable on top of the Taptic engine, The watch turns on fine but I can’t use the screen. I don’t know if it’s because of that or something else. Any help will be much appreciated!! Thanks a lot!!! You’ll need to replace the Taptic engine for starters. But that doesn’t explain why your watch is not working....
Chosen Solution I replaced the battery and everything worked perfectly. 6 days later the phone is dead and charging has no effect. Phone is otherwise in perfect condition, and I followed the battery replacement instructions very carefully. Any suggestions? Most likely you got a dud battery, factories generally do not test batteries before they are sent out. I would suggest to contact whomever you purchased your battery from.
Chosen Solution (SAMSUNG FE) Replaced the digitiser using an aftermarket OLED frame, the phone is now stuck bootlooping. Ive unplugged and taken the phone apart a few times only with the same result. Any tips would be appreciated, thanks! Hi Hannah I suggest to buy the original OEM PART from the phone as sometimes the after market parts may not be recognised by the Original Hardware thanks
