Chosen Solution

The stabilizer may get damaged when the drone loses connectivity and crashes. The plastic housing (which contains the electronics) that plugs into the drone is bolted on with 5 bolts. That housing can break apart ripping the stabilizer in two. I need to source and replace the housing and the electronics to salvage the rest of the stabilizer. Any chance you have that information and want to make a video of the process? Stabilizer codes that I can see: -outside housing-MISP-REM-WD7-KWCY1 -large board- 656-10811 Rev A –this board has two snap-in ribbon cables and one slide in 3 cable connector (the connector ripped of the board) -small board- couldn’t see it -three ribbon cables –656-11925-000 REV A –656-19296-000 REV A (MOT -170804261) – this one ripped in two. Can’t see code until taken apart.

  • stabilizer has a code inside it: E5272800335148 (which is printed on the part that is not part of the broken plastic housing.)
  • I can send photos if necessary. Thank you.

Hello I have this problem also, any idea where PCB 656-10811 rev A might be purchased?