Chosen Solution
This Kenmore 110 42926 220 washer look like it should work. But when you press the start button nothing happens, yet the leds come on solid ( not flashing ). The door doesn’t lock , ETC. I tried to reset by pulling the AC off for twenty minutes several times. Then unplug /plug AC, shut the door and hold both the Start and cancel in for an count of twenty. I tried to enter the diagnostic mode but it wouldn’t come on . I tried several methods suggested by Online and U-TUBE. Is there a different way to enter the diagnostic then the others or does this mean the CC module isn’t working right ?
I believe this is very similar to the model I have. Here is what I did to run a diagnostic. With the washer empty, close the door. Push “control/on” or “Start”Select “Drain/Spin” Select “No Spin” by pressing SPIN SPEED touchpad. Push “PREWASH” option four times within 5 seconds. (If there is no PREWASH option, press RINSE HOLD 4 times in 5 seconds.) C:00 should light up and begin the diagnostic.
Tap drain/spin button. Tap spin speed button until it gets to “ no spin”. Tap the “prewash” button 4 times. Diagnosis will start.
Hold down any button ,besides start and stop for 3 sec, off 3 sec, on 3 sec off 3 sec until all lights come on and panel reads 88
