Chosen Solution
I replaced one of the defective solenoid valve but when i run the washer water will come in and after a couple of minutes drain valve is draining the water and after that F8 will flash in the control.
F8 The washer tub does not empty within 7 minutes. The wash cycle will continue. The F 8 w ill fl ash three times, then wait for 30 seconds. The error will clear at the end of the cycle. Check VFD fault code before turning off power. Check to ensure the drain valve is operating properly (slow drain has potential to cause this code). Check to ensure the pressure switch tube is clear of any blockage, and the pressure switch is operating properly. Check the pressure switch harness
I press the start button on machine comes on the tub spins but no water comes in I replace both water valves and the drain valve the washer is only a year old.
