Chosen Solution

Just replace clutch in truck no clutch pedal goes to floor without fully engaging need to adjust or bleed system. How to bleed clutch. How to adjust.

@mnorton196969 BLEEDING CLUTCH SYSTEM

  1. Clean and remove reservoir cap. Top-off reservoir with NEW DOT 3 brake fluid.
  2. Have an assistant depress and hold clutch pedal. Open bleed screw located on left side of transmission to expel air. Close bleed screw and release clutch pedal. NOTE: DO NOT reuse fluid that has been bled from system.
  3. Repeat procedure until all air is out of system. Check and refill reservoir as needed during bleeding. After bleeding, pump clutch pedal several times. If clutch engagement is not satisfactory, repeat bleeding procedure.
  4. If normal bleeding procedure is unsuccessful, perform the following: Remove reservoir capPump pedal very fast for 30 seconds.Stop to allow air to escapeRepeat procedure as necessary