Chosen Solution
I was curious if anyone had a video on replacing the charging port on a Hisense Sero 7 Pro? I’ve youtubed it and can only find one video that was made without Audio. It looks like the charging port is soldered in place. I don’t have any experience with soldering and was wondering if this is something that can be accomplished with a standard soldering iron or would it require a specialized micro soldering iron? Thanks in advance for suggestions or advice.
Most devices don’t solder there charging ports to the devices, But If it dose you should take it in the be repaired because if you’re inexperienced you may mess something up.
Going off this video: https://www.youtube.com/watch?v=cAoAe2si… Yes, it is soldered on. It doesn’t look like anything special. A couple of anchor points and 5 traces. I don’t personally consider this micro soldering and do this kind of repair with a standard iron. I use the Xtronic 5040 which is not mirco at all. Since this device is relatively inexpensive, this may be a good thing to learn on. Watch a few charging port repair videos (they are all the same) and then give it a go. Just remember never to pull up on the port since that can tear pads.
